Mechanical Seals

The Mechanical Seal is readily accessible, not hidden in the stuffing box, so it’s easy to install and replace. Since the proper spring compression is preset, there are only three steps to installation. Just slide the rotary unit over the shaft until it comes in contact with the stationary face, tighten the drive ring to the shaft, and remove the retaining clips.

The Seals are designed for use
• where an outside seal is required,
• as a low cost replacement for seals made of exotic metals,
• in corrosive fluids that attack inside-mounted mechanical seals,
• in food processing where the seal must be cleaned in place for sanitation.

This seal has no metal parts in direct contact with the pumped fluid. The multiple springs are also isolated from the fluid. Unlike reverse-mounted inside seals, the seals are hydraulically balanced for use as an outside seal.

Wilt u meer weten over de mogelijkheden van onze mechanical seals, neem dan vrijblijvend contact met ons op of vraag hieronder een vrijblijvende offerte aan.

Get in touch

    You can request a quotation without obligation

    At the moment we are busy translating our website. It is possible that certain pages have not yet been translated. Our apologies.

    X
    Share This